Custom AR15 6mmx45 Upper

[Domonicm]

Price

600$-800$

Item Location

Valrico

Custom 6mmx45 upper, (for AR15 lower)
Paladin 1/10 twist custom reamed barrel, Fail Zero bolt/ full BCG, mod rail, gas port.
SWFA 20 SS x42 scope and rings.
This was one of 6 custom batch run off for our Virginia rifle group.
Less than 500 rounds thru with test ammo for load analysis, and tested out to 500 yards. (75- 87-95g)

please Note: unless you are a confident and prolific reloader this is not for you, as all ammo is custom construction involving re-necking 223/556 brass to 6mm.

Will include 6mmx45 dies, 6mm neck ream, a few boxes of hornady bullets also some brass casings (used ex military nickel that will require cleaned and decrimped)

This is a Closet toy as I am not presently set up for reloading here , but a fun cheap upper for long range plinking or hunting and addition to your AR15 lower.
Fully functional and just uses standard 223/556 lower

Upper and Scope -$800
Upper only - $600

(A2 upper in picture not included but also available)

Local sale within 1hour travel no shipping
No scam replies

 

[Bowhntr6pt]

Just a comment...

I have an 18" 6x45 AR15 and using Winchester brass (have not used any other) the reloading process is straight forward... don't be intimidated. Using a set of Hornady Custom dies in 6mm x 45mm, with a tapered expander ball, sizing brass is a breeze.

Gets you a 6mm bullet in the AR15 size package. A very light recoiling package.

My rifle with a "budget" barrel...



Easily capable of MOA and less accuracy with no real testing of powders or bullets... it's an inherently accurate cartridge... I just stopped here as it's good enough for minute of hog.

 

[Domonicm]

Thanks, yes I usually factory size 223/556 brass ( Lee #2 shell holder), and neck to 6mm with the reamer, and then seat the bullet to mag length. This custom build is a 24inch barrel with front brake and favors 87g.
87g VMax 2726 with H335 25.4g (2716 with 87g Varmit) which will group moa at 100yds.
2963 with 75g VMax.
I ran this out to 500yds and easily hit 24inch plates

The bolt is upgraded due to the higher pressure and used the military nickel brass.

a little gun porn below, my custom lower with Geissele trigger

 

[Domonicm]

Bump for reasonable offers or possible interesting trades +/-

 

[kaferhaus]

I'm interested but would require shipping to Mobile

 

[Domonicm]

Thanks Kaferhaus, looking for a local sale at the moment as a few included items to go with and I hate wrapping. But if I head back to Mobile again I will let you know.

 

[Domonicm]

Bump for a unique range toy !

 

[Domonicm]

Bump
Still available

 

[Domonicm]

Bump
still up for grabs, add a caliber upgrade to your AR