Just got this in, a new FS/MB for my AR. had to make a adapter to put it on, will try it out Sunday if the weather isn't to bad. What do you think. just my 5 cents jj
Report: The good part No recoil, bad part a lot of blast come's back on you, the first few shot at 200 is on and after that it want stay on the 10" plate, that could be from the about 2lb weight that it put on the front of the barrel, this may work better on a 50cal. but not sure you could stand the blast the comes back. Frank you should recognize it and know the manufacture. I'm sure you have seen one before. just my 5 cents jj
It looked familiar that is why I asked but I am old and have the cantremembershit disease...I think I will just go w a suppressor if I have to carry the weight.
Have looked at the pic several times and still can't figure out:
1.What is it ??
2. What is it supposed to do ??
3. Is that a hole for a pin or a set screw ??
4. What is the chambering of the weapon ??
5. Ummmmmm ...... "no recoil" ?? ---- SAWMAN
It is to control flash and muzzle recoil it is on one of my 556's hole is for a set screw , what is it wasn't you in the military , think c-130 and a couple of other things just made a adapter , just for a fun of it. Found it in a junk metal pile, and just couldn't resist it. I thought you would be one the first to know what it was. Just my 5 cents