Ok here goes. Started to take the series 80 stuff out of the Taurus and started with the slide. Problems right off. The fireing pin stop won't budge. I pushed the little do hickie out of the way and pushed the fireing pin in and got it out of the way and released the do hickie and the fireing pin stayed in like it is supposed to.
Now the problem. The fireing pin stop will not move. I even hit it with a hammet and punch an no go. Checked it and the fireing pin is staying in and didn't slide out . Stopped and put the slide back on. You would think they pressed the damn thing in it is so tight. Any one else ever run into this problem.
Sure dont want to cut it out and buy a new one.:noidea:
Now the problem. The fireing pin stop will not move. I even hit it with a hammet and punch an no go. Checked it and the fireing pin is staying in and didn't slide out . Stopped and put the slide back on. You would think they pressed the damn thing in it is so tight. Any one else ever run into this problem.
Sure dont want to cut it out and buy a new one.:noidea:
